This is a post I wrote awhile back, but now includes a significant update (see below) that makes the whole thing worthy of re-purposing. Windows and Mac users should stop reading now lest their heads explode.
A Great Wireless Card
Switching to Linux from Windows is no longer as difficult as it used to be. I hope to post a full-fledged guide on switching to Linux in the near future, but in the mean time I would like to address one difficulty that has plagued would-be Linux users for some time: wireless cards and driver support. The persistent problem with Linux is that hardware manufacturers only program for Windows. The Linux community, with all its hacker ingenuity, has overcome this obstacle for most hardware, and big companies such as Intel and ATI have recently come-around and opened-up their drivers. Two problem areas remain, however: graphics cards and wireless cards.
The latter has given me a problem for some time, particularly with our old laptop. Built in cards usually work fine, but those PCMCIA and USB cards rarely include native Linux support. So, to cut to the chase, for all those Linux users out there, let me recommend the ASUS WL-107G. It redefines plug-and-play, which is not one of Linux’s strengths. Seriously, I removed my old card, stuck this in its slot, and with every expectation of needing to poke and proud, was sorely dissapointed to discover that the card in question “just worked.” OpenSUSE (and later Ubuntu) immediately recognized the card, installed the driver, accessed my WPA2-AES network, and was up-and-googling within 30 seconds. Amazing. If I hadn’t spend 2 months trying to get my Linksys card to behave, I would have said something like “Let’s see Windows do that!”
In short, the ASUS WL-107G is a PCMCIA notebook wireless card that runs in Linux, Windows, and Mac. It supports WEP, WPA, WPA2, with either TKIP or AES. In short, it will meet whatever security needs you have, in whatever Operating System you run, and for about $40 less than most other wireless cards with these specifications. If you are running a Linux box, and have had trouble with wireless, this is the card for you.
Important Update: Increase your Speed
For this and other cards based on the ralink 2×00 chipset (the WL-107G uses the rt2500 chipset), you may run into slow internet speeds when you first install. I did in Ubuntu. This is because the ralink drivers for some reason default to a 1 mbs data rate. To fix this, type the following into a terminal:
sudo iwconfig wlan0 rate 54M
You should be operating at normal speeds. You can use http://speed.io to test your speeds before and after marking the change.
